Starting up LedshowTW2018, click " setup " -->setup parameters -->password:888, get into the setup page.
There are 3 normal choices in " Quickly scan configuration "
Outdoor P10: 1/4(27)→ 2.8; Data polarity: Negative; OE polarity: High;
Outdoor P16: 1/4(27)→ 2.9; Data polarity: Positive; OE polarity: Low;
Indoor module: 1/16(1)→0.0; Data polarity: Negative; OE polarity: Low;
When you click " Quickly scan configuration ", these above parameters are tolerant, and just some very special modules need you modify the data and OE polarity!(Notes: new functions in Ledshow TW2012)
After these done, you are supposed to click " Set scan ". (It is important ,users should remember)
Then, inputting the wide pixels and high pixels according to your screen→ click " Write parameters ",→Close→Edit.
Floor 7, Tower 88, 1199#, North Qinzhou Road,Xuhui District,shanghai,China
Post Code:200233
Copyright (C) 2008 Shanghai ONBON Technology Inc. Web all rights reserved
沪ICP备08109710号 沪公网安备 31010402000803号