Fast setting steps for BX controller

1. After installing LedshowTW2012, start it, click " setup " -->set parameters -->password:888, get into the set-up page.
2. Choosing the corresponding model from " Controller "; Choosing " serial communication" or "GPRS communication", or" network communication "; Choosing " width " and " height " (display the pixels of width and height); Choosing " screen color " (single or double color); Choosing " Data Polarity "(P10 outdoor single red is " negative "); Choosing " OE Polarity " (P10 outdoor single red is " high ")
3. After finishing the above parameters, U disk card-clicking " save ", then " save scan configuration "(outdoor P10 2.8); Serial port card-clicking "  writing parameters ", then " set scan "(outdoor P10 2.8), then clicking " close ".
4. Getting into " Subtitle ", serial port card-clicking " send programs ". U disk card-clicking " USB " download to U disk, and if you want the time synchronization, please " √ " under the downloading bar of " USB ". Unplugging the U disk from computer, and programs will transmit to U disk automatically if inserting the U disk card.

Notes:
In LedshowTW2012, when entering into the module of set screen parameters, it could identify automatically and select correctly the communicating serial port and Ethernet; And reading automatically the present parameters; Meanwhile, optimizing the auto correlation of default option between scan configuration and set screen parameters module, made the process easier!